Rohde & Schwarz MXO 4 Series - Page 282

ApplicationsMXO 4 Series
282User Manual 1335.5337.02 ─ 07
Voltage
Selects the channel for the voltage source.
Remote command:
POWer<m>:HARMonics:SOURce[:VOLTage] on page 686
Current
Selects the channel for the current source.
Remote command:
POWer<m>:HARMonics:SOURce:CURRent on page 685
Fund. Freq
Selects the frequency of the input signal. The available frequencies depend on the
selected Standard.
Remote command:
POWer<m>:HARMonics:FREQuency:EN on page 686
POWer<m>:HARMonics:FREQuency:MIL on page 687
POWer<m>:HARMonics:FREQuency:RTCA on page 687
Standard
Select the standard in use.
Table 11-1: Current harmonic precompliance standards
Standard Application
EN 61000-3-2 Class A Balanced 3-phase equipment, household appliances (excluding equip-
ment identified as class D), tools (excluding portable tools), dimmers for
incandescent lamps, audio equipment
EN 61000-3-2 Class B Portable tools, not professional arc welding equipment
EN 61000-3-2 Class C Lighting equipment
EN 61000-3-2 Class D PC, PC monitors, radio, or TV receivers with an input power less than or
equal to 600W
MIL-STD-1399 Military shipboard user equipment
RTCA DO-160 Environmental tests of avionics hardware
Remote command:
POWer<m>:HARMonics:STANdard on page 686
Displ. Harm.
Selects which harmonics are displayed in the bargraph: all, odd even or depending on
the standard definition.
Remote command:
POWer<m>:HARMonics:DISPlay:HARMonics on page 688
Scale bar graph
Selects a logarithmic or linear scale for the display for the harmonics bargraph.
Power analysis (option R&S
MXO4-K31)