Rohde & Schwarz MXO 4 Series - Page 688

Remote control commandsMXO 4 Series
688User Manual 1335.5337.02 ─ 07
POWer<m>:HARMonics:DISPlay:HARMonics <DispedHarmonics>
Selects which harmonics are displayed in the bargraph: all, odd even or depending on
the standard definition.
Suffix:
<m>
.
1...3, index of the power analysis measurement
Parameters:
<DispedHarmonics> ALL | EVEN | ODD | STANdard
*RST: STANdard
Usage: Asynchronous command
Manual operation: See "Displ. Harm." on page 282
POWer<m>:HARMonics:DISPlay:FREQuency:STARt
<Frequency>
Sets the start frequency of bar graph display. At least three bars are displayed.
Suffix:
<m>
.
1...3, index of the power analysis measurement
Parameters:
<Frequency> Range: 0 to 100000000
Increment: 1
*RST: 50
Default unit: Hz
Usage: Asynchronous command
Manual operation: See "Min X Frequency" on page 284
POWer<m>:HARMonics:DISPlay:FREQuency:STOP <Frequency>
Sets the stop frequency of the bar graph display. The maximum value is defined by
standard and fundamental frequency.
Suffix:
<m>
.
1...3, index of the power analysis measurement
Parameters:
<Frequency> Range: 0 to 100000000
Increment: 1
*RST: 1000
Default unit: Hz
Usage: Asynchronous command
Manual operation: See "Max X Frequency" on page 284
POWer<m>:HARMonics:DISPlay:BARGraph:VERTical:SCALe:TYPE <Scaling>
Selects a logarithmic or linear scale for the display for the harmonics bargraph.
Applications