ApplicationsMXO 4 Series
283User Manual 1335.5337.02 ─ 07
Remote command:
POWer<m>:HARMonics:DISPlay:BARGraph:VERTical:SCALe:TYPE
on page 688
Clear Results
Clears all current results and resets the statistics.
Remote command:
POWer<m>:HARMonics:STATistics:RESet on page 687
Power harmonic results
The results of the Harmonic measurements are provided in two ways:
●
The diagram shows the graphical presentation of the voltage waveform, the current
waveform and the power waveform
●
The result box displays a bar chart and a table with the numerical measurement
results. The number of displayed harmonics depends on the standard definition.
When you tap on a harmonic in the bar chart, the respective row in the result box is
displayed.
The current harmonic results displayed in the result box are defined as follows:
Result table Bar chart match Description
THDF - Total harmonic distortion relative to the fun-
damental
THDR - Total harmonic distortion relative to the RMS
amplitude
Harmonic index Value of the x-axis The harmonic order
Frequency - The frequency value of the signal
Magnitude Value of the y-axis. Shown
by a green bar
The present value of the current harmonic
Power analysis (option R&S MXO4-K31)
To Next Page
Loading...
