Rohde & Schwarz MXO 4 Series - Page 361

Protocol analysisMXO 4 Series
361User Manual 1335.5337.02 ─ 07
"Field"
Enables the field type that you want to filter on for the selected frame.
The available field is "Data".
Remote command:
SBUS<sb>:UART:FILTer:FIENable on page 759
SBUS<sb>:UART:FILTer:FRAMe<fr>:FLD<fl>:ENABle
on page 759
"Condition"
Displays the value condition for the selected field.
Remote command:
SBUS<sb>:UART:FILTer:FRAMe<fr>:FLD<fl>:BIT
on page 758
"Data"
The data setup consists of a comparison condition and one or two
data patterns.
Remote command:
SBUS<sb>:UART:FILTer:FRAMe<fr>:FLD<fl>:DMAX
on page 758
SBUS<sb>:UART:FILTer:DMAX on page 758
SBUS<sb>:UART:FILTer:FRAMe<fr>:FLD<fl>:DMIN
on page 757
SBUS<sb>:UART:FILTer:DMIN on page 757
SBUS<sb>:UART:FILTer:FRAMe<fr>:FLD<fl>:DOPerator
on page 757
SBUS<sb>:UART:FILTer:DOPerator on page 757
"Index"
The index setup consists of a comparison condition and one or two
index values.
Remote command:
SBUS<sb>:UART:FILTer:FRAMe<fr>:FLD<fl>:IMAX
on page 756
SBUS<sb>:UART:FILTer:IMAX on page 756
SBUS<sb>:UART:FILTer:FRAMe<fr>:FLD<fl>:IMIN
on page 755
SBUS<sb>:UART:FILTer:IMIN on page 755
SBUS<sb>:UART:FILTer:FRAMe<fr>:FLD<fl>:IOPerator
on page 756
SBUS<sb>:UART:FILTer:IOPerator on page 756
Error type
Enables filtering on the selected error type.
Available error types are "Start error", "Stop error", "Parrity error", "Break".
Remote command:
SBUS<sb>:UART:FILTer:ERRor<n>:ENABle on page 757
UART (option R&S
MXO4-K510)