Rohde & Schwarz RTE Series - Page 1480

Remote control commands
R&S
®
RTE
1480User Manual 1326.1032.02 ─ 20
BUS<m>:UART:BITRate <Bitrate>
Sets the number of transmitted bits per second.
Suffix:
<m>
.
1..4
Parameters:
<Bitrate> Range: 300 to 20000000
Increment: 1
*RST: 9600
Default unit: bps
Usage: Asynchronous command
BUS<m>:UART:BAUDrate <Bitrate>
Same as BUS<m>:UART:BITRate.
Suffix:
<m>
.
1..4
Parameters:
<Bitrate> Range: 300 to 20000000
Increment: 1
*RST: 9600
Default unit: bps
Usage: Asynchronous command
BUS<m>:UART:PARity <Parity>
Defines the optional parity bit that is used for error detection.
See also: "Parity" on page 554.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Parity> NONE | ODD | EVEN | MARK | SPC | DC
MARK
The parity bit is always a logic 1.
SPC
SPaCe: The parity bit is always a logic 0.
DC
Don't Care: the parity is ignored.
*RST: NONE
Usage: Asynchronous command
Protocols