Rohde & Schwarz RTE Series - Page 1535

Remote control commands
R&S
®
RTE
1535User Manual 1326.1032.02 ─ 20
TRIGger<m>:LIN:DLECondition <DLCOperator>
Operator to set the data length for triggering on LIN data.
For Big Endian transfer direction, you can trigger on a number of bytes less than the
data length of the frame, that means, on the first bytes that are transmitted. For Little
Endian transfer direction, the exact number of data bytes in the frame must be set.
Example: The data word to be sent is 12 34 56, and it is sent little endian by the LIN
node. With Data length ≥ 2 and Transfer = Big endian, you trigger on the data of the
first two bytes, that is 56 34. With Data length = 3 and Transfer = Little endian, you trig-
ger on the required data word 12 34 56.
The number of data bytes to be found is set with TRIGger<m>:LIN:DLENgth
on page 1535.
See also:TRIGger<m>:LIN:BORDer on page 1534 .
Parameters:
<DLCOperator> EQUal | GETHan
For little endian transfer direction, EQUal must be set.
*RST: GETHan
TRIGger<m>:LIN:DLENgth <WordCount>
Sets the length of the bit pattern to be found, in bytes. For "Big Endian" transfer direc-
tion, you can trigger on a number of bytes less than the data length of the frame, that
means, on the beginning of the data pattern. For "Little Endian" transfer direction, the
exact number of data bytes in the frame must be set.
For complete definition, set also the operator with TRIGger<m>:LIN:DLECondition
on page 1535.
Parameters:
<WordCount> Range: 1 to 8
Increment: 1
*RST: 1
TRIGger<m>:LIN:IDOR<n>:ENABle <UseIdentifier>
Includes the indicated IDOR address in the "identifier OR" trigger condition.
Suffix:
<n>
.
1..4
Index of the identifier in an "identifier OR" condition
Parameters:
<UseIdentifier> ON | OFF
*RST: OFF
Protocols