Rohde & Schwarz RTE Series - Page 1550

Remote control commands
R&S
®
RTE
1550User Manual 1326.1032.02 ─ 20
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:DLECondition <SearchName>,<DLCOperator>
SEARch:TRIGger:LIN:DLECondition? <SearchName>
Operator to set the data length for search on LIN data.
For Big Endian transfer direction, you can trigger on a number of bytes less than the
data length of the frame, that means, on the first bytes that are transmitted. For Little
Endian transfer direction, the exact number of data bytes in the frame must be set.
Example: The data word to be sent is 12 34 56, and it is sent little endian by the LIN
node. With Data length ≥ 2 and Transfer = Big endian, you trigger on the data of the
first two bytes, that is 56 34. With Data length = 3 and Transfer = Little endian, you trig-
ger on the required data word 12 34 56.
The number of data bytes to be found is set with SEARch:TRIGger:LIN:DLENgth.
See also: SEARch:TRIGger:LIN:BORDer on page 1549.
Parameters:
<DLCOperator> EQUal | GETHan
For little endian transfer direction, EQUal must be set.
*RST: GETHan
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:DLENgth <SearchName>,<WordCount>
SEARch:TRIGger:LIN:DLENgth? <SearchName>
Sets the length of the bit pattern to be found, in bytes.
For complete definition, set the operator using SEARch:TRIGger:LIN:
DLECondition, and the transfer direction with SEARch:TRIGger:LIN:BORDer.
Parameters:
<WordCount> Range: 1 to 8
Increment: 1
*RST: 1
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:IPERror <SearchName>,<IdParityError>
SEARch:TRIGger:LIN:IPERror? <SearchName>
Searches for errors in the identifier parity bits. These are the bits 6 and 7 of the identi-
fier.
Protocols