Rohde & Schwarz RTE Series - Page 162

Instrument setup
R&S
®
RTE
162User Manual 1326.1032.02 ─ 20
SW option list
Shows the activated options. This information provided for administration and trouble-
shooting purposes. If you need support for an option, provide this information to the
service representative.
The "State" of the option indicates whether the installed option is a normal or a beta-
release version. Beta-release versions must be activated explicitly in the "Mode" dialog
box (see Chapter 4.9.4, "Options in beta state", on page 165).
Material number, Serial number, Device ID
Indicates the material number, serial number and the device identification string
(device ID) of your instrument. These numbers, in particular the device ID, are required
to order a new option, or to move a portable option.
Remote command:
DIAGnostic:SERVice:PARTnumber on page 1087
DIAGnostic:SERVice:SERialnumber? on page 1087
SYSTem:DEVice:ID? on page 1086
Enter new option key
Enter the license key here to activate the option. For license keys delivered as a file,
use Install from file. Only users with administrator rights can activate options.
Install from file
If you got a license file, install the license here.
Tap "Open" to open the file selection dialog, or enter the complete path and filename.
For details, see Chapter 12.7, "File selection dialog", on page 511. Only users with
administrator rights can activate options.
Options