Protocol analysis
R&S
®
RTE
741User Manual 1326.1032.02 ─ 20
Note: The displayed parameters depend on the selected "Sequence". The instrument
displays the data setting parameters when you select "Status+Data", see "Type"
on page 738.
Figure 13-63: Trigger setting parameters of a transmission sequence
Sequence ← Transmission Sequence setup
Selects the condition for triggering in a single transmission sequence.
You can trigger on the end of the status nibble or the combination of the status and
data nibbles.
Remote command:
TRIGger<m>:SENT:TTYPe on page 1707
Status ← Transmission Sequence setup
Defines the data bits for the status nibble.
Remote command:
TRIGger<m>:SENT:STATus on page 1707
Condition ← Transmission Sequence setup
Selects the operator to define a specific data pattern or a data range.
The available operators:
●
Equal, Not equal
●
Less than, Greater than
●
Less or equal, Greater or equal
●
In range, Out of range
Remote command:
TRIGger<m>:SENT:TDCN on page 1708
Nibbles ← Transmission Sequence setup
Displays the number of data nibbles of the transmission sequence.
Remote command:
BUS<m>:SENT:DNIBbles on page 1704
SENT (option R&S
RTE-K10)
To Next Page
Loading...
