Protocol analysis
R&S
®
RTE
762User Manual 1326.1032.02 ─ 20
Condition ← Transmission Sequence setup
Selects the operator to define a specific data pattern or a data range.
The available operators:
●
Equal, Not equal
●
Less than, Greater than
●
Less or equal, Greater or equal
●
In range, Out of range
Remote command:
SEARch:TRIGger:SENT:TDCN on page 1722
Data Nibbles ← Transmission Sequence setup
Sets the number of data units in a single transmission sequence.
The maximum number of data nibbles is 6.
Remote command:
BUS<m>:SENT:DNIBbles on page 1704
Data min ← Transmission Sequence setup
Sets the data pattern. Enter the bytes in msb first bit order. The maximum pattern
length is 64 bit. Waveform data is compared with the pattern byte-by-byte.
Remote command:
SEARch:TRIGger:SENT:TDMN on page 1722
Data max ← Transmission Sequence setup
The second data pattern is required to specify a range with conditions "In range" and
"Out of range".
Remote command:
SEARch:TRIGger:SENT:TDMX on page 1722
Serial Message setup
Configures the search conditions for a serial message.
Note: The displayed parameters depend on the selected "Sequence". The instrument
indicates the data setting parameters when you select "ID+Data", see "Sequence"
on page 763.
The description of the search type specific settings are the same as for the trigger type,
see "Serial Message setup" on page 742.
Search setting parameters of the serial message types
Short Serial Message Enhanced Serial Message
SENT (option R&S RTE-K10)
To Next Page
Loading...
