Instrument Function
R&S
®
SMU200A
417Operating Manual 1007.9845.32 ─ 15
Output Settings
The "Output Settings" section in the multi carrier main menu indicates the name, the size
and the clock rate of the currently calculated multi carrier output file.
File
Opens the "File" menu, where the output file name of the multi carrier waveform which
has to be calculated can be entered.
The multi carrier waveform is calculated and saved under this name by clicking the
"Create" or "Create and Load" button.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:OFILe on page 607
Clock Rate
Displays the resulting sample rate at which the multi carrier waveform is output by the
arbitrary waveform generator. The output clock rate depends on the number of carriers,
carrier spacing and input sample rate of the leftmost or rightmost carriers.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:CLOCk on page 603
File Size
Displays the resulting number of samples of the multi carrier waveform.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:SAMPles on page 608
Create
Creates a new multi carrier waveform defined by the multi carrier table and General Set-
ting entries.
This multi carrier waveform is saved with the file name specified in "Output File". If no file
name is specified, the File Manager opens so that the file name can be entered. As with
normal waveforms, the file extension is *.wv.
Baseband Signal - Baseband Block
To Next Page
Loading...
