Image Processing
ARCADIS Varic
SPR2-310.620.30.02.02 31
of 78
Limiting the playback
range
The bar display labels the images of the scene with bars. The left and right bor-
ders show the first and last image of the playback range.
◆ Drag the border bar to the first and last image of the desired playback range.
Starting movie mode In movie mode the images of one series are displayed in a loop. After the last
image of the series, the first image is displayed again etc.
Movie mode cannot be started in the following situation (the button Start Movie
Real Time does not react): three patients are loaded in Viewing, a fourth patient
is being registered and a scene (multiframe object) is being recorded.
You have the following possibilities to optimize movie display and set the speed
according to your requirements:
❏ slowly
❏ real time
❏ fast
◆ Select Scroll > Realtime Movie or click the button.
– The film is started with the original frame rate.
Or
◆ Select Scroll > Movie at half frame rate or click the button.
– The movie is started with half the frame rate.
Or
◆ Select Scroll > Movie at double frame rate or click the button.
– The movie is started with double the frame rate.
The playback speed may be reduced by postprocessing activities, edge enhance-
ment or subtraction.
To Next Page
Loading...
Need help?
General
