Operator Manual
30
of 98 SPR2-310.620.30.02.02
Documentation
Selecting one or more
images explicitly
â—† Click into a segment holding the Ctrl key down.
– The segment is marked with a line border.
Selecting images
explicitly up to the end
of a series
â—† Click on the image that you want to select explicitly holding the Ctrl key down
or use the input focus.
â—† Select Edit > Select On Succeeding.
– The selected image and all the following images are now selected.
Selecting a complete
series explicitly
â—† Click on the image of the series that you want to select holding the Ctrl key
down or use the input focus.
â—† Select Edit > Select series.
– The whole series is now selected explicitly.
Deselecting images â—† Hold the Ctrl button pressed.
â—† Click on an explicitly selected image again.
Or
â—† Select Edit > Deselect All.
– All selected images are deselected.
– After that, the default input focus is set automatically, i.e. the top left seg-
ment is the destination of the next action.
To Next Page
Loading...
Need help?
General
