Command groups
Table 2-40: Trigger commands (cont.)
Command
Description
TRIGger:{A|B}:UPPerthreshold:CH<x> Sets or queries the CH<x> upper trigger level.
TRIGger:{A|B}:WINdow:CROSSIng Sets or queries the window trigger threshold crossing of the selected trigger Source.
TRIGger:{A|B}:WINdow:LOGICQUALification Specifies whether or not to use logic qualification for a window trigger.
TRIGger:{A|B}:WINdow:SOUrce Sets or queries the source for a window trigger.
TRIGger:{A|B}:WINdow:WHEn Sets or queries the window trigger event.
TRIGger:{A|B}:WINdow:WIDth Sets or queries the minimum width for a window violation.
TRIGger:{A|B|B:RESET} S ets the A, B, or B Reset trigger level automatically to 50% of the range of the
minimum and maximum values of the trigger input signal.
TRIGger:A:HO LDoff:BY S ets or queries the type of holdoff for the A trigger.
TRIGger:A:HO L Doff:TIMe Sets or queries the A trigger holdoff time.
TRIGger:A:LOGICQU ALification Sets or queries the type of logic qualification to perform.
TRIGger:A:MO De Sets or queries the A trigger mode.
TRIGger:AUXLevel Sets or queries the Auxiliary Input voltage level to u se for a n edge trigger.
TRIGger:B:BY S ets or queries B trigger time or event qualifiers.
TRIGger:B:EVENTS:COUNt Sets or queries the number of events that must occur before the B trigger occurs.
TRIGger:B:RESET Sets the B reset trigger level to 50% .
TRIGger:B:RESET:EDGE:COUPling Sets or queries the trigger coupling for a sequential edge trigger reset when the
Source is set to an analog channel.
TRIGger:B:RESET:EDGE :LEVel Sets the voltage level to use for an Edge Reset trigger when triggering on an analog
channel waveform.
TRIGger:B:RESET:EDGE :SLOpe Sets or queries the trigger slope for a sequential edge trigger reset.
TRIGger:B:RESET:EDGE :SOUrce Sets or queries the trigger source for the A→B sequential edge trigger reset feature.
TRIGger:B:RES ET:TIMEOut:TIMe Sets or queries the reset timer for a sequential timeout trigger reset.
TRIGger:B:RESET:TYPe S ets or queries the type of A →B sequential trigger reset.
TRIGger:B:STATE Returns the current state of the triggering system.
TRIGger:B:TIMe Sets or queries the B trigger delay time.
TRIGger:STATE? Returns the current state of the triggering system.
2-84 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
