To Next Page

To Previous Page

Commands listed in alphabetical order

CH<x>:PRObe:

AUTOZero (No Query Form)

This command executes the attached probe’s Auto Zero function, for probes that

support this feature. See your probe documentation for more details. The channel

is speciﬁed b

yx.

Group

Vertical

Syntax

CH<x>:PRObe:AUTOZero EXECute

Arguments

EXECute sets the probe attached to the speciﬁed channel to autozero.

Examples

CH1:PROBE:AUTOZERO EXECUTE sets the probe attached to the Channel 1 to

autozero.

CH<x>:PRObe:DEGAUSS (No Query Form)

This command starts a degauss cycle of the TekVPI probe attached to the speciﬁed

channel. The channel is speciﬁed by x.

Group

Vertical

Syntax

CH<x>:PRObe:DEGAUSS EXECute

Arguments

EXECute starts the degauss cycle.

Examples

CH1:PROBE:DEGAUSS EXECUTE causes the probe attached to Channel 1 to

degauss.

CH<x>:PRObe:DEGAUSS:STATE? (Query Only)

This command queries whether the probe attached to the speciﬁed channel

requires a degauss operation. The channel is s peciﬁed by x.

Group

Vertical

Syntax

CH<x>:PRObe:DEGAUSS:STATE ?

2-196 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Programmer's Manual

Other manuals for Tektronix MSO54