Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
SEARCH:SEARC
H<x>:TRIGger:A:BUS:FLEXRAY:DATa:HIVALue
This command sets or queries the high value when searching on a FlexRay bus
data field. The search number is specified by <x>. The search condition must be
set to IDANDD
ATA O R D ATA .
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS
:FLEXRAY:DATa:HIVALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A :BUS:FLEXRAY:DATa:HIVALue?
Arguments
<QString> specifiesthedatavalue.
Examples
SEARCH:SEARCH1:TRIGger:A:B US:FLEXRAY:DATa:HIVALue " 1010" sets
the data value to XXXXXX1010.
SEARCH:SEARCH1:TRIGger:A:B US:FLEXRAY:DATa:HIVALue? might
return
:SEARCH:SEARCH1:TRIGGER:A :BUS:FLEXRAY:DATA:HIVALUE
"XXXXXXXXXX"
, indicating the data value is a don’t care.
SEARCH:SEARCH<x>:TRIGger:A:BUS:FLEXRAY:DATa:OFFSet
This command sets or q ueries the offset of the data string, in bytes, when
searchingonaFlexRaybusdatafield. The search number is specified by <x>.
The search condition must be set to IDANDDATA OR DATA.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:FLEXRAY:DATa:OFFSet <NR3>
SEARCH:SEARCH<x>:TRIGger:A :BUS:FLEXRAY:DATa:OFFSet?
Arguments
<NR3> specifies the data offset in bytes. A setting of X/Don’t care is accomplished
by setting the offset to –1.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-665

Tektronix MSO54 Specifications

General

Analog Channels	4
Sample Rate	6.25 GS/s
Vertical Resolution	12-bit
Form Factor	Benchtop
Probe Interface	TekVPI
Operating Temperature	0 °C to +50 °C
Bandwidth	1 GHz
Record Length	62.5 Mpoints
Display	15.6 inch HD
Waveform Update Rate	>500, 000 wfms/s
Trigger Types	Edge, Pulse, Runt, Logic, Serial
Serial Bus Support	I2C, SPI, RS-232/422/485/UART, CAN/CAN FD/LIN, USB 2.0, Ethernet
Connectivity	USB, Ethernet
Input Impedance	1 MΩ
Power Requirements	100-240 VAC, 50/60 Hz
Maximum Input Voltage	400 V (DC + peak AC)