Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Conditions
Requires the SR
-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:CONDition
{SOF|FRAMEtype|IDentifier |DATa|IDANDDATA|EOF|ERRor|FDBITS}
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:CONDition?
Arguments
Arguments specify the CAN bus trigger condition.
Examples
SEA
RCH:SEARCH1:TRIGger:A:BUS: CAN:CONDition EOF
sets the CAN
bus trigger condition to end of frame.
SE
ARCH:SEARCH1:TRIGger:A:BUS: CAN:CONDition?
might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:CAN:CONDITION SOF, indicating the
CAN bus trigger condition is set to start of frame.
S
EARCH:SEARCH<x>:TRIGger:A:BUS:CAN:DATa:DIRection
This command specifies the CAN search type to be valid on a Read, Write, or
Either condition. The search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:DATa:DIRection
{READ|WRITE|NOCARE}
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:DATa:DIRection?
Arguments
READ specifies the read direction.
WRITE specifies the write direction.
NOCARE specifies either data direction.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:CAN:DATa:DIRection RE AD sets the
data direction to
READ.
SEARCH:SEARCH1:TRIGger:A: BUS:CAN:DATa:DIRection? might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:CAN:DATA:DIRECTION N OCARE
indicating the data direction is set to either data direction.
2-642 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English