Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Arguments
<NR3> is the cur
sor position.
Examples
DISplay:PLOTView<x>:CURSor :HBArs:APOSition 2.0 sets the cursor to
2 Volts.
DISplay:PLOTView<x>:CURSor :HBArs:APOSition? might return
:DISPLAY:PLOTVIEW1:CURSOR: HBARS:APOSITION 2.2
186
indicating the
HBArs cursors are at 2.2186 Volts.
DISplay:PLOTView<x>:CURSor:HBArs:AUNIts? (Query Only)
This command queries the cursor A vertical units of the specified cursor in the
specified view.
Group
Cursor
Syntax
DISplay:PLOTView<x>:CURSor :HBArs:AUNIts?
Returns
A <QString> that is the cursor horizontal units.
Examples
DISplay:PLOTView1:CURSor:H BArs:AUNIts? might return
:DISPLAY:PLOTVIEW1:CURSOR: HBARS:AUNITS "V" indicating the A units
are Volts.
DISplay:PLOTView<x>:CURSor:HBArs:BPOSition
This command sets or queries the vertical cursor B position of the specified cursor
in the specified view.
Group
Cursor
Syntax
DISplay:PLOTView<x>:CURSor :HBArs:BPOSition <NR3>
DISplay:PLOTView<x>:CURSor :HBArs:BPOSition?
Arguments
<NR3> is the HBArs vertical position.
Examples
DI
Splay:PLOTView<x>:CURSor:HB Ars:BPOSition 2.0
sets the cursor to
2 Volts.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-251

Tektronix MSO54 Specifications

General

Analog Channels	4
Sample Rate	6.25 GS/s
Vertical Resolution	12-bit
Form Factor	Benchtop
Probe Interface	TekVPI
Operating Temperature	0 °C to +50 °C
Bandwidth	1 GHz
Record Length	62.5 Mpoints
Display	15.6 inch HD
Waveform Update Rate	>500, 000 wfms/s
Trigger Types	Edge, Pulse, Runt, Logic, Serial
Serial Bus Support	I2C, SPI, RS-232/422/485/UART, CAN/CAN FD/LIN, USB 2.0, Ethernet
Connectivity	USB, Ethernet
Input Impedance	1 MΩ
Power Requirements	100-240 VAC, 50/60 Hz
Maximum Input Voltage	400 V (DC + peak AC)