Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Examples
TRIGGER:B:RES
ET:EDGE:COUPLING
HFREJsetshighfrequencylow
sensitivity.
TRIGGER:B:RESET:EDGE:COUP LING? might return
:TRIGGER:B:RESET:EDGE:COUPLING DC indicating DC trigger coupling
is selected.
TRIGger:B:RESET:EDGE:LEVel
This command sets the voltage level touseforanEdgeResettriggerwhen
triggering on an analog channel waveform.
Group
Trigger
Syntax
TRIGger:B:RESET:EDGE:LEVe l <NR3>
Arguments
<NR3> is the voltage level to use for a
n Edge Reset trigger when triggering on
an analog channel waveform.
Examples
TRIGGER:B:RESET:EDGE:LEVE L 50.0
e-3 sets the level to 50.0 mV.
TRIGGER:B:RESET:EDGE:LEVE L? might return
:TRIGGER:B:RESET:EDGE:LEVEL 0.0E+0 indicating the level is set to 0.0 V.
TRIGger:B:RESET:EDGE:SLOpe
This command sets or queries the trigger slope for a sequential edge trigger res et.
Group
Trigger
Syntax
TRIGger:B:RESET:EDGE:SLOp e {RISe|FALL|EITher}
TRIGger:B:RESET:EDGE:SLOp e?
Arguments
RISe specifies to reset the trigger on the rising or positive edge of a signal.
FALL specifies to reset the trigger on the falling or negative edge of a signal.
EITHER specified to reset the trigger on either the rising o r falling edge of a signal.
Examples
TRIGGER:B:RESET:EDGE:SLOP E FALL specifies to reset the trigger on the
falling or negative edge of a signal.
2-880 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English