Commands listed in alphabetical order
Examples
MEASUREMENT:F
ILTERS:LOWPASS:SPEC SECOND
specifies a second order low
pass filter.
MEASUREMENT:FILTERS:LOWPAS S:SPEC? might return
:MEASUREMENT:FILTERS:LOWPA SS:SPEC NONE indicating no low
pass filter.
MEASUrement:FILTers:RAMPtime
This command sets or queries the global filter ramp time for the measurement.
Group
Measurement
Syntax
MEASUrement:FILTers:RAMPti me <NR3>
MEASUrement:FILTers:RAMPti me?
Arguments
<NR3> is the c urrent filter r amp time.
Examples
MEASUREMENT:FILTERS:RAMPTI ME 3.0 sets the ramp time to 3.0.
MEASUREMENT:FILTERS:RAMPTI ME? might return
:MEASUREMENT:FILTERS:RAMPT IME 2.0000 indicating the ramp time is 2.0.
MEASUrement:GATing
This command sets or queries the global gating type for the measurement.
Group
Measurement
Syntax
MEASUrement:GATing {NONE|SCREEN|CUR Sor|LOGic|SEARch }
MEASUrement:GATing?
Arguments
NONE turns off measurement gating.
SCREen turns o n gating, using the left and right edges of the screen.
CURSor limits measurements to the portion of the waveform between the vertical
bar cursors, even if they are off screen.
LOGic specifies that measurements are taken only on the portion of the waveform
wherethelogicsourceisintheactivestate.
SEARCH specifies that measurements are taken based on search crite ria.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-405
To Next Page
Loading...
Need help?
General
