Commands listed in alphabetical order
For Cycle Base m
easurement, the parameters is “LOW”.
For Cycle Max measurement, the parameters is “MAX”.
For Cycle Min measurement, the parameters is “MIN”.
Examples
POWer:POWer1:RESUlts:ALLA cqs:MEAN? "TruePwr" might return
38.7856097255943E–9, indicating the mean value of true power for all
acquisitions.
POWer:POWer<x>:RESUlts:ALLAcqs:MINimum? (Query Only)
This command queries the minimum value of all acquisitions for the measurement
parameter in the specified power m easurement ba dge. The power measurement
badge is specified by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group
Power
Syntax
POWer:POWer<x>:RESUlts:AL LAcqs:MINimum? <QString>
Arguments
<QString> = parame ters of the measurements. The details of the p arameters for
the Power measurements are listed below:
For Power Quality measurement, the parameters are "TRUEPWR" | "APPPWR"
| "REPWR" | "PWRFACTOR" | "PHASE" | "PWRFREQ" | "ICFACTOR" |
"VCFACTOR" | "IRMS" | "VRMS".
For Switching Loss measurement, the parameters are "TONENRG" | "TONLOSS"
| "TOFFENRG" | "TOFFLOSS" | "CONDENRG" | "CONDLOSS" | "TTLLOSS" |
"TTLENRG".
For dV by dt m easurement, the parameter is “DVBYDT”.
For dI by dt measurement, the parameter is “DIBYDT”.
For SOA measurement, the parameter is “SOAHITSCNT”.
For Line Ripple measurement, the parameters are “LRIPRMS” | “LRIPPKPK”.
For Switching Ripple measurement, the p arameters are “SWRIPRMS” |
“SWRIPPKPK”.
For Cycle Period measurement, the parameters is “PRIOD”.
For Cycle Frequency measurement, the parameters is “FREQ”.
2-564 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
