Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Syntax
MEASUrement:C
LOCKRecovery:NOMINALOFFset <NR3>
MEASUrement:CLOCKRecovery: NOMINALOFFset?
Arguments
<NR3> is the global clock offset.
Examples
MEASUREMENT:CLOCKRECOVERY: NOMINALOFFSET 1.0 sets the offset to 1.0.
MEASUREMENT:CLOCKRECOVERY: NOMINALOFFSET? might return
:MEASUREMENT:CLOCKRECOVERY :NOMINALOFFSET 0.0E+0 indicating the
offset is set to 0.0.
MEASUrement:CLOCKRecovery:NOMINALOFFset:SELECTIONtype
This command sets or queries the global offset type used when explicit clock
recovery is used for the measurement. This will affect measurements whose
:MEASUrement:MEAS<x>:CLOCKRecovery:GLOBal flag is set to 1.
Group
Measurement
Syntax
MEASUrement:CLOCKRecovery: NOMINALOFFset:SELECTIONtype
{AUTO|MANUAL}
MEASUrement:CLOCKRecovery: NOMINALOFFset:SELECTIONtype?
Arguments
AUTO sets the selection type to AUTO.
MANUAL sets the selection type to MANUAL.
Examples
MEASUREMENT:CLOCKRECOVERY: NOMINALOFFSET:SELECTIONTYPE AUTO
sets the selection type to auto.
MEASUREMENT:CLOCKRECOVERY: NOMINALOFFSET:SELECTIONTYPE? might
return
:MEASUREMENT:CLOCKRECOVERY:N OMINALOFFSET:SELECTIONTYPE
MANUAL
indicating the selection type is manual.
MEASUrement:CLOCKRecovery:STAndard
This command sets or queries the global communications standard used when
PLL clock recovery is used for the measurement. This will affect measurements
whose :MEASUrement:MEAS<x>:CLOCKRecovery:GLOBal flag is set to 1.
Group
Measurement
MSO54, MSO56, MSO58, MSO58LP Programmer 2-399

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English