Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
LOWer specifies
that the instrument triggers when the signal remains below the
lower threshold for longer than the time limit and then crosses upwards through
the lower threshold.
EITher specifies that the instrument triggers when the signal remains either above
the upper threshold or below the lower threshold for longer than the time limit
andthencrossesathreshold.
NONe specifies that the instrument triggers w hen the signal remains outside the
upper and lower thresholds for longer than the time limit without crossing through
either the upper or lower threshold.
Examples
SEARCH:SE
ARCH1:TRIGger:A:WINdow:POL arity LOWER
sets the polarity
to lower.
SEARCH:SEARCH1:TRIGger:A: WINdow:POLarity? might return
:SEARCH:SEARCH1:TRIGGER:A :WINDOW:POLARITY UPPER indicating the
polarity is set to upper.
SEARCH:SEARCH<x>:TRIGger:A:WINdow:SOUrce
This command sets and queries the source for the window s
earch input. The
search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:WINdow:SOUrce
{CH<x>|MATH<x>|REF<x>}
SEARCH:SEARCH<x>:TRIGger: A:WINdow:SOUrce?
Arguments
Arguments are the available sources.
Examples
SEARCH:SEARCH1:TRIGger:A: WINdow:SOUrce CH2 sets the source to
channel 2.
SEARCH:SEARCH1:TRIGger:A: WINdow:SOUrce? might return
:SEARCH:SEARCH1:TRIGGER:A :WINDOW:SOURCE CH3 indicating the source
is channel 3.
SEARCH:SEARCH<x>:TRIGger:A:WINdow:THReshold:HIGH
This command sets or queries the source threshold HIGH level for a transition
trigger search to determine where to place a mark. The search number is specified
by <x>.
2-748 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English