Commands listed in alphabetical order
MEASUrement:
MEAS<x>:BITType
This command sets or queries the bit type for the measurement. Measurements
are specified by x.
Group
Measurem
ent
Syntax
MEASUrement:MEAS<x>:BITTyp e
{ALLBits|TRANSition|NONTRA Nsition}
MEASUrement:MEAS<x>:BITTyp e?
Arguments
ALLBits specifies that the measurement returns results for all bits.
TRANSition specifies that the measurement returns results for transitions bit only.
NONTRANsition specifies that the measurement returns results for non-transition
bits only.
Examples
MEASUrement:MEAS1:BITType TRANSITION specifies that the measurement
returns results for transition bits only.
MEASUrement:MEAS1:BITType? might return
:MEASUREMENT:MEAS1:BITTYPE ALLBITS indicating that measurements
return results for all bits.
MEASUrement:MEAS<x>:BURSTEDGTYPe
This command sets or queries the burst edge type for the measurement.
Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:BURSTE DGTYPe {RISE|FALL}
MEASUrement:MEAS<x>:BURSTE DGTYPe?
Arguments
RISE specifies a burst with a rising edge.
FALL specifies a burst with a falling e dge.
Examples
MEASUrement:MEAS2:BURSTEDG TYPe FALL specifies a burst with a falling
edge.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-425
To Next Page
Loading...
Need help?
General
