Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Group
Calibration
Syntax
CALibrate?
Examples
CALIBRATE? might return :CALIBRATE:INTERNAL:S TATUS PASS, indicating
the calibration status.
CALibrate:INTERNal (No Query Form)
This command (no query form) starts the signal path calibration (SPC) of the
instrument. You can use the CALibrate:INTERNal:STATus? query to return the
current status of the signal path calibration of the instrument.
NOTE. When running SPC through the remote interface, calibration status cannot
be obtained until after the SPC completes. SPC takes approximately 5 minutes per
channel which means a total of 40 minutes on an 8-channel model. Any remote
command that performs an action on the oscilloscope is also disabled until the
SPC is complete.
Group
Calibration
Syntax
CALibrate:INTERNal
Related Commands
CALibrate:INTERNal:STATus?
Examples
CALIBRATE:INTERNAL starts the signal path calibration of the instrument.
CALibrate:INTERNal:STARt (No Query Form)
This command (no query form) starts the signal path calibration (SPC) of the
analog channels. This command is the same as the CALibrate:INTERNal
command. You can use the CALibrate:INTERNal:STATus? querytoreturnthe
current status of the signal path calibration of the instrument.
NOTE. When running SPC through the remote interface, calibration status cannot
be obtained until after the SPC completes. SPC takes approximately 5 minutes per
channel which means a total of 40 minutes on an 8-channel model. Any remote
command that performs an action on the oscilloscope is also disabled until the
SPC is complete.
2-186 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English