Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
SEARCH:SEARCH
1:TRIGger:A:BUS:AUDio:DATa:Q UALifier?
might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:AUDIO:DATA:QUALIFIER EQUAL
indicating the qualifier is set to EQUAL.
SEARCH:SEAR
CH<x>:TRIGger:A:BUS:AUDio:DATa:TDMVALue
This command sets or queries the binary data string for the single
or low data word to be used when searching on an TDM audio
bus signal
. The search condition must be set to DATA using
SEARCH:SEARCH{x}:TRIGger: A:BUS:AUDio:CONDition.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:AUDio:DATa:TDMVALue <QString>
SEARCH:SEARCH<x>:TRIGger: A:BUS:AUDio:DATa:TDMVALue?
Arguments
<QString> is the binary data string for the single or low data word to be used
when searching on an TDM audio bus signal.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:AUDio:DATa:TDMVALue " 1100" sets
the TDM VALUE to 1100.
SEARCH:SEARCH1:TRIGger:A: BUS:AUDio:DATa:TDMVALue?
might
return :SEARCH:SEARCH1:TRIGGER:A:BUS:AUDIO:DATA:TDMVALUE
"XXXXXXXXXXXXXXXXXXXX1010" indicating the TDM value is 1010.
SEARCH:SEARCH<x>:TRIGger:A:BUS:AUDio:DATa:VALue
This command sets or queries the binary data string for the
single or low data word to be u sed when searching on an audio
bus signal. The search condition must be set to DATA using
SEARCH:SEARCH<x>:TRIGger: A:BUS:AUDio:{NONTdm|TDM}:CONDition.
The search number is specified by <x>.
Conditions
Requires the SR-AUDIO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:AUDio:DATa:VALue <Q String>
SEARCH:SEARCH<x>:TRIGger: A:BUS:AUDio:DATa:VALue?
2-640 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English