To Next Page

To Previous Page

Commands listed in alphabetical order

Group

Bus

Syntax

BUS:B<x>:LIN:SAMPLEpoint <NR1>

BUS:B<x>:LIN:SAMPLEpoint?

Arguments

<NR1> is a percentage that represents the point at which to sample during each

bit period.

Examples

BUS:B1:LIN:SAMPLEPOINT 10 sets the sample point to 10% of the bit period

BUS:B1:LIN:SAMPLEPOINT? might return BUS:B1:LIN:SAMPLEPOINT 50

indicating that the sample point is set to 50% of the bit period

BUS:B<x>:LIN:SOUrce

This command sets or queries the LIN data source for the speciﬁed bus. The

bus number is speciﬁed by x.

Conditions

Requires option SR-AUTO.

Group

Bus

Syntax

BUS:B<x>:LIN:SOUrce

{CH<x>|CH<x>_D<x>|MATH<x> |REF<x>|REF<x>_D<x>}

BUS:B<x>:LIN:SOUrce?

Arguments

Arguments specify the available sources.

Examples

BUS:B1:LIN:SOUrce MATH4 sets the source to MATH 4

BUS:B1:LIN:SOUrce? might return :BUS:B1:LIN:SOU RCE CH1, indicating

thesourceissettochannel1.

BUS:B<x>:LIN:SOUrce:THReshold

This command sets or queries the LIN source threshold for the speciﬁed bus. The

bus is speciﬁed by x.

Conditions

Requires option SR-AUTO.

2-154 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Programmer's Manual

Other manuals for Tektronix MSO54