To Next Page

To Previous Page

Commands listed in alphabetical order

MEASUrement:M

EAS1:COMMONMode:SOURCEs?

might return

:MEASUREMENT:MEAS1:COMMONM ODE:SOURCES DOUBLE indicating sources

are set to double.

MEASUrement

:MEAS<x>:CYCLemode

This command sets or queries the cycle mode for the measurement. Measurements

are speciﬁed by x.

Group

Measurement

Syntax

MEASUrement:MEAS<x>:CYCLem ode {RECORD|CYCLE}

MEASUrement:MEAS<x>:CYCLem ode?

Arguments

RECORD speciﬁes that the measurement is taken o ver the whole record.

CYCLE speciﬁes that measurements are taken on each cycle of the source.

Examples

MEASUrement:MEAS1:CYCLemod e CYCLE sets the measurement to be taken

over each cycle of the source.

MEASUrement:MEAS1:CYCLemod e? might return

:MEASUREMENT:MEAS1:CYCLEMO DE RECORD indicating the measurement is

taken over the whole record.

MEASUrement:MEAS<x>:DELay:EDGE<x>

This command sets or queries the 'to edge' type when EDGE<x> is EDGE1 and

the 'from edge' type when EDGE<x> is EDG2, for the measurement when the

measurement type is DELAY. Measurements are speciﬁed by x.

Group

Measurement

Syntax

MEASUrement:MEAS<x>:DELay: EDGE<x>

{FALL|RISe|BOTH|SAMEas|OPP ositeas}

MEASUrement:MEAS<x>:DELay: EDGE<x>?

Related Commands

MEASUrement:MEAS<x>:TOEdge

MSO54, MSO56, MSO58, MSO58LP Programmer 2-441

Tektronix MSO54 Programmer's Manual

Other manuals for Tektronix MSO54