Commands listed in alphabetical order
SEARCH:SEARCH
1:TRIGger:A:PULSEWidth:WHEn?
might return
:SEARCH:SEARCH1:TRIGGER:A: PULSEWIDTH:WHEN WITHIN indicating that a
search will occur when a pulse is detected that is within a set range.
SEARCH:SEAR
CH<x>:TRIGger:A:RUNT:LOGICQUALification
This command specifies whether or not to use logic qualification for a runt search.
Thesearchnumberisspecified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :RUNT:LOGICQUALification {ON|OFF}
SEARCH:SEARCH<x>:TRIGger:A :RUNT:LOGICQUALification?
Arguments
ON specifies to use logic qualification for a runt search.
OFF specifies not to use logic qualification for a runt search.
Examples
SEARCH:SEARCH1:TRIGger:A:R UNT:LOGICQUALification ON turns on
logic qualification.
SEARCH:SEARCH1:TRIGger:A:R UNT:LOGICQUALification? might return
:SEARCH:SEARCH1:TR IGGER:A:RUNT:LOGICQUALIFICATION OFF
indicating logic qualification is off.
SEARCH:SEARCH<x>:TRIGger:A:RUNT:POLarity
This command specifies the polarity for the runt search. The search number is
specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :RUNT:POLarity
{POSitive|NEGative|EITher}
SEARCH:SEARCH<x>:TRIGger:A :RUNT:POLarity?
Arguments
POSitive specifies using positive polarity for the runt search.
NEGative specifies using negative polarity for the runt search.
EITher specifies us
ing either positive or negative polarity for the runt search.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-727
To Next Page
Loading...
Need help?
General
