Commands listed in alphabetical order
Arguments
<NR1> is the loc
ation (control in divisions) where the waveform label for the
selected reference is displayed, relative to the left edge of the screen.
Examples
REF:REF4:LABEL:XPOS 10 moves the waveform label for the Reference 3
waveform, so that it begins 10 divisions to the right of the left edge of the screen.
REF:REF2:LABEL:XPOS? might return :R EF:REF2:LABEL:X POS 1.5,
indicating that the x-axis for the Reference 2 waveform is currently 1.5 divisions
to the right of the left edge of the screen.
REF:REF<x>:LABel:YPOS
This command sets or queries the Y-position of the label (attached to the displayed
waveform of the specified reference), relative to the baseline of the waveform.
The reference waveform is specified by x.
Group
Vertical
Syntax
REF:REF<x>:LABel:YPOS <NR1>
REF:REF<x>:LABel:YPOS?
Arguments
<NR1> is the location where the waveform label for the selected reference is
displayed, relative to the baseline of the waveform.
Examples
REF:REF3:LABEL:YPOS -10 moves the waveform label for the Reference 3
waveform 10 vertical units below the baseline of the waveform.
REF:REF2:LABEL:YPOS? might return :REF:REF2 :LABEL:YPOS 0, indicating
that the waveform label for the Reference 2 waveform is currently located at
the baseline of the waveform.
REF:REF<x>:SOUrce
This command sets or queries the filename used by the given reference.
Group
Vertical
Syntax
REF:REF<x>:SOUrce <QString>
Arguments
<QString> is the reference file name.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-605
To Next Page
Loading...
Need help?
General
