Commands listed in alphabetical order
SEARCH:SELec
ted
This command sets or q ueries the selected search, for example SEARCH1. The
search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SELected SEARCH1
Arguments
SEARCH1 is the specified search.
Examples
SEARCH:SELected SEARCH1 specifies a search 1 search.
SEARCH:SELected? might return :SEARCH:SELECT ED SEARCH1 indicating
search 1 is selected.
SET? (Query Only)
This query-only command returns the commands that list the instrument settings,
except for configuration information for the calibration values. You can use these
commands to return the instrument to the
state it was in when you made the SET?
query. The SET? query always returns command headers, regardless of the setting
of the HEADer command. This is because the returned commands are intended
to be sent back to the instrument as a command string. The VERBose command
can still be used to specify whether the returned headers should be abbreviated
or full-length.
This command is identical to the *LRN? command.
Group
Miscellaneous
Syntax
SET?
Related Commands
HEADer, *LRN?, VERBose
Examples
SET? might return the following response: :A CQUIRE:STOPAFTE R
RUNSTOP;STATE 1;MODE SAMPLE;NUMENV 10;NUMAVG 16;REPET
1;:FASTACQ:STATE 0;:APPLICATION:GPK NOB1:ACTIVE
0;:APPLICATION:GPKNOB2:ACT IVE 0;:APPLICATION:WINDOW:HE IGHT
236;WIDTH 640;:APPLICATION:SCOPEAPP:ST ATE
RUNNING;WINDOW FULLSCREEN;:APPLICAT ION:EXTAPP:STATE
MSO54, MSO56, MSO58, MSO58LP Programmer 2-751
To Next Page
Loading...
Need help?
General
