Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Arguments
PERCent specifi
es that the reference levels are calculated as a percent
relative to HIGH and LOW. The percentages are defined using the
MEASUrement:REF<x>:REFLev el:PERCent commands.
ABSolute specifies that the reference levels are set explicitly using the
MEASUrement:REF<x>:REFLev el:ABSolute commands. This method is
useful when precise values are required.
Examples
MEASUrement:REF1:REFLevel s:METHod ABSOLUTE specifies that the
reference levels are set explicitly.
MEASUrement:REF1:REFLevel s:METHod? might return
:MEASUREMENT:REF1:REFLEVE LS:METHOD PERCENT indicating the
reference levels are calculated as a percent relative to HIGH and LOW.
MEASUrement:REF<x>:REFLevels:PERCent:FALLHigh
This command sets or queries the percentage (where 100% is equal to TOP and
0% is equal to BASE) used to calculate the high reference level of the falling edge
when the measurement's ref level method is set to percent.
Group
Measurement
Syntax
MEASUrement:REF<x>:REFLev els:PERCent:FALLHigh <NR3>
MEASUrement:REF<x>:REFLev els:PERCent:FALLHigh?
Arguments
<NR3> is the percentage used to calculate the high refe renc
e level of the falling
edge
Examples
MEASUrement:REF1:REFLevel s:PERCent:FALLHigh 95 sets the reference
level to 95%.
MEASUrement:REF1:REFLevel s:PERCent:FALLHigh? might return
:MEASUREMENT:REF1:REFLEVE LS:PERCENT:FALLHIGH 90.00 00 indicating
the reference level is 90%.
MEASUrement:REF<x>:REFLevels:PERCent:FALLLow
This command sets or queries the percentage (where 100% is equal to TOP and
0% is equal to BASE) used to calculate the low reference level of the falling edge
when the measurement's ref level method is set to percent.
2-512 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English