Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Examples
BUS:B1:ETHERN
ET:IPVFOUR NO
will specify that Bus 1 does not have IPV4
packets available.
BUS:B3:ETHERNET:IPVFOUR? might return :BUS:B3:ETHERNET:IPV FOUR
YES
indicating that Bus 3 has IPV4 packets available.
BUS:B<x>:ETHERnet:LOWTHRESHold
This command sets or queries the Ethernet source Low threshold for the specified
bus. This threshold only applies when the Ethernet signal type is differential. The
bus is specified by x.
Conditions
Requires option SR-ENET.
Group
Bus
Syntax
BUS:B<x>:ETHERnet:LOWTHRES Hold <NR3>
BUS:B<x>:ETHERnet:LOWTHRES Hold?
Related Commands
BUS:B<x>:ETHERnet:SIGNALTYpe
Arguments
<NR3> is the Ethernet source Low threshold for the specified bus.
Examples
BUS:B1:ETHERnet:LOWTHRESHo ld -200e-3 sets the threshold to -200 mV.
BUS:B1:ETHERnet:LOWTHRESHo ld? might return
:BUS:B1:ETHERNET:LOWTHRESH OLD -500.0000E-3 indicating the threshold
is set to -500 mV.
BUS:B<x>:ETHERnet:QTAGGING
This command sets or queries whether Q-Tagging packets are available for
triggering on Ethernet. The bus is specified by x.
Conditions
Requires option SR-ENET.
Group
Bus
Syntax
BUS:B<x>:ETHERnet:QTAGGING {YES|NO}
BUS:B<x>:ETHERnet:QTAGGING ?
MSO54, MSO56, MSO58, MSO58LP Programmer 2-135

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English