Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Group
Measurement
Syntax
MEASUrement:REF<x>:REFLeve ls:PERCent:FALLLow <NR3>
MEASUrement:REF<x>:REFLeve ls:PERCent:FALLLow?
Arguments
<NR3> is the percentage used to calculate the low reference level
Examples
MEASUrement:REF1:REFLevels :PERCent:FALLLow 5 sets the low reference
level to 5%.
MEASUrement:REF1:REFLevels :PERCent:FALLLow? might return
:MEASUREMENT:REF1:REFLEVEL S:PERCENT:FALLLOW 10.0000 indicating
the low reference level is 10%.
MEASUrement:REF<x>:REFLevels:PERCent:FALLMid
This command sets or queries the percentage (where 100% is equal to TOP and
0% is equal to BASE) used to calculate the mid reference level of the falling edge
when the measurement's ref level method is set to percent.
Group
Measurement
Syntax
MEASUrement:REF<x>:REFLeve ls:PERCent:FALLMid <NR3>
MEASUrement:REF<x>:REFLeve ls:PERCent:FALLMid?
Arguments
<NR3> is the percentage used to calculate the mid reference level of the falling
edge.
Examples
MEASUrement:REF1:REFLevels :PERCent:FALLMid 55 sets the reference
level to 50%.
MEASUrement:REF1:REFLevels :PERCent:FALLMid? might return
:MEASUREMENT:REF1:REFLEVEL S:PERCENT:FALLMID 50.0000 indicating
the mid reference level is 50%.
MEASUrement:REF<x>:REFLevels:PERCent:HYSTeresis
This command sets or queries the percentage (where 100% is equal to MAX and
0% is equal to MIN) used to calculate the hysteresis of the reference level when
the measurement's ref level method is set to percent.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-513

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English