Commands listed in alphabetical order
To change the pa
ssword, you must first enter the valid password with the
PASSWord command and then change to your new password with the NEWpass
command. Remember that the password is case sensitive.
Group
Miscellaneous
Syntax
PASSWord <QString>
Related Commands
NEWpass, *PUD
Arguments
<QString> is the password, which can contain up to 10 characters. The factory
default password is “XYZZY” and is always valid.
Examples
PASSWORD "XYZZY" enables the *PUD and NEWPass set commands.
PASSWORD disables the *PUD and NEWPass set commands. You can still use the
query version of *PUD.
PAUSe (No Query Form)
This command causes the interface to pause the specified number of seconds
before processing any other commands.
Group
Miscellaneous
Synta
x
PAUSe < NR3>
Arguments
<NR3> is the specified number of seconds the interface is to pause before
processing any other commands. The pause time is specified as a floating point
value in seconds and must be > 0.0 and ≥1800
.0.
Examples
PAUSE 10 .0e0;:ACQUIRE:NU MACQ causes the interface to pause 10 seconds
before returning the number of acquisitions.
PLOT:ADDNew (No Query Form)
This command adds the specified plot.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-519
To Next Page
Loading...
Need help?
General
