Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Examples
DISplay:MATHF
FTView1:XAXIS:SCALE LOG
specifies a logarithmic scale.
DISplay:MATHFFTView1:XAXIS :SCALE? might return
:DISPLAY:MAT
HFFTVIEW1:XAXIS:SCALE LINEAR
indicates the
scale setting is linear.
DISplay:MATHFFTView<x>:YAXIS:SCALE
This command sets or queries the vertical scale setting for FFT Maths, either
Linear or dBm.
Group
Display Control
Syntax
DISplay:MATHFFTView<x>:YAX IS:SCALE {LINEAr|DBM}
DISplay:MATHFFTView<x>:YAX IS:SCALE?
Arguments
LINEAr specifies a linear scale.
DBM specifies a dBm scale.
Examples
DISplay:MATHFFTView1:YAXIS :SCALE LINEAR specifies a linear scale.
DISplay:MATHFFTView1:YAXIS :SCALE? might return
:DISPLAY:MATHFFTVIEW1:YAXI S:SCALE DBM incicating the scale
is dBm.
DISplay:MATHFFTView<x>:ZOOM:XAXIS:FROM
This command sets or queries the value of the left edge of the specified plot view.
Group
Zoom
Syntax
DISplay:MATHFFTView<x>:ZOO M:XAXIS:FROM <NR3>
DISplay:MATHFFTView<x>:ZOO M:XAXIS:FROM?
Arguments
<NR3> is the value of the left edge of the zoom x axis in the specified plot view.
Examples
DISplay:MATHFFTView1:ZOOM: XAXIS:FROM 800.e6 sets the x axis value of
the left edge of the plot view to 800 MHz.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-245

Tektronix MSO54 Specifications

General

Analog Channels	4
Sample Rate	6.25 GS/s
Vertical Resolution	12-bit
Form Factor	Benchtop
Probe Interface	TekVPI
Operating Temperature	0 °C to +50 °C
Bandwidth	1 GHz
Record Length	62.5 Mpoints
Display	15.6 inch HD
Waveform Update Rate	>500, 000 wfms/s
Trigger Types	Edge, Pulse, Runt, Logic, Serial
Serial Bus Support	I2C, SPI, RS-232/422/485/UART, CAN/CAN FD/LIN, USB 2.0, Ethernet
Connectivity	USB, Ethernet
Input Impedance	1 MΩ
Power Requirements	100-240 VAC, 50/60 Hz
Maximum Input Voltage	400 V (DC + peak AC)