Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
SAVEON:FILE:
NAME
Sets or queries the file name to use when SAVEON:TRIGer is ON.
Group
Save On
Syntax
SAVEON:FILE:NAME <QString>
SAVEON:FILE:NAME?
Related Commands
SAVEON:FILE:DEST
Arguments
<QString> is the file name you want to use.
Examples
SAVEON:FILE:NAME "MaskFailure" sets the name of the file to MaskFailure.
SAVEON:FILE:NAME? might return ":S AVEON:FILE:NAME MaskFailure5 ",
indicating the name you set for the oscilloscope to use, with the autoincrement
number (5) appended.
SAVEON:IMAGe
This command sets or queries whether to save a screen capture when a trigger
occurs and SAVEON:TRIGer is ON and SAVEON:IMAGE is O N..
Group
Save On
Syntax
SAVEON:IMAGe {<NR1>|OFF|ON}
SAVEON:IMAGe?
Related Commands
SAVEON:FILE:DEST, SAVEON:FILE:NAME, SAVEON:TRIGger,
SAVEON:IMAGe
Arguments
<NR1> = 0 disables Save On Image; any other value turns this feature on.
OFF disables Save On Image.
ON enables Save On Image.
Examples
SAVEON:IMAGE ON sets the oscilloscope to save a screen capture on a specified
trigger.
2-624 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Analog Channels	4
Sample Rate	6.25 GS/s
Vertical Resolution	12-bit
Form Factor	Benchtop
Probe Interface	TekVPI
Operating Temperature	0 °C to +50 °C
Bandwidth	1 GHz
Record Length	62.5 Mpoints
Display	15.6 inch HD
Waveform Update Rate	>500, 000 wfms/s
Trigger Types	Edge, Pulse, Runt, Logic, Serial
Serial Bus Support	I2C, SPI, RS-232/422/485/UART, CAN/CAN FD/LIN, USB 2.0, Ethernet
Connectivity	USB, Ethernet
Input Impedance	1 MΩ
Power Requirements	100-240 VAC, 50/60 Hz
Maximum Input Voltage	400 V (DC + peak AC)