Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
MEASUrement:
MEAS<x>:COMMONMode:FILTers:STATE
This command sets or queries whether a filter is used for the measurement when
the measureme nt type is AC common mode. Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:COMMO NMode:FILTers:STATE {OFF| ON|0|1}
MEASUrement:MEAS<x>:COMMO NMode:FILTers:STATE?
Arguments
OFF turns the filter off.
ON turns the filter on.
0 turns the filter off.
1 turns the filter on.
Examples
MEASUrement
:MEAS1:COMMONMode:FILTers:S TATE ON
sets the filter to on.
MEASUrement:MEAS1:COMMONM ode:FILTers:STATE? might return
:MEASUREME
NT:MEAS1:COMMONMODE:FILTERS: STATE 0
indicating the fi lter
is off.
MEASUrement:MEAS<x>:COMMONMode:SOURCEs
This command s ets or queries the number of sources for the meas urement when
the measureme nt type is AC common mode. Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:COMMO NMode:SOURCEs {SINGLE|DOUBLE }
MEASUrement:MEAS<x>:COMMO NMode:SOURCEs?
Arguments
SINGLE specifiesasinglesource.
DOUBLE specifies double sources.
Examples
MEASUreme
nt:MEAS1:COMMONMode:SOURCE s SINGLE
specifiesasingle
source.
2-440 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English