To Next Page

To Previous Page

Commands listed in alphabetical order

Group

Measurement

Syntax

MEASUrement:CH<x>:REFLevel s:PERCent:RISEMid <NR3>

MEASUrement:CH<x>:REFLevel s:PERCent:RISEMid?

Arguments

<NR3> is the percentage (where 50% is equal to MID) used to calculate the mid

reference level when the measurement's Ref l evel method is set to Percent.

Examples

MEASUREMENT:CH2:REFLEVELS: PERCENT:RISEMiD 50.0000 sets the MID

reference level for the rising edge to 50%.

MEASUREMENT:CH2:REFLEVELS: PERCENT:RISEMID? might return

:MEASUREMENT:CH2:REFLEVELS :PERCENT:RISEMID 50.0000 indicating the

MID reference level for the rising edge is set to 50%.

MEASUrement:CH<x>:REFLevels:PERCent:TYPE

This command speciﬁes or queries the reference level percent type for the

measurement. The channel number is speciﬁed by x.

Group

Measurement

Syntax

MEASUrement:CH<x>:REFLevel s:PERCent:TYPE

{TENNinety|TWENtyeighty|CU STom}

MEASUrement:CH<x>:REFLevel s:PERCent:TYPE?

Arguments

TENNinety speciﬁes reference levels at the 10 and 90% levels.

TWENtyeighty speciﬁes refe

rence levels at the 20 and 80% levels.

CUSTom speciﬁes custom reference levels.

Examples

MEASUREMENT:CH2:REFLEVELS: PERCENT:TYPE TENNINETY sets the

reference levels to the 10 and 90% levels.

MEASUREMENT:CH2:REFLEVELS: PERCENT:TYPE? might return

:MEASUREMENT:CH2:REFLEVELS :PERCENT:TYPE TWENTYEIGHTY indicating

the reference levels are set to the 20 and 80% levels.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-391

Tektronix MSO54 Programmer's Manual

Other manuals for Tektronix MSO54