Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Conditions
Requires the SR
-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:FLEXRAY:EOFTYPE
{ANY|STATIC|DYNAMIC}
SEARCH:SEARCH<x>:TRIGger: A:BUS:FLEXRAY:EOFTYPE?
Arguments
ALL specifies either end of file type.
S
TATIC
specifies the static end of file type.
DYNAMIC spe cifies the static end of file type.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:FLEXRAY:EOFTYPE STATI C sets the
end of file type to static.
SEARCH:SEARCH1:TRIGger:A: BUS:FLEXRAY:EOFTYPE? might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:FLEXRAY:EOFTYPE ANY, indicating
either end of file type will cause a trigger.
SEARCH:SEARCH<x>:TRIGger:A:BUS:FLEXRAY:ERRTYPE
This command sets or queries the error type when searching on a FlexRay bus
signal. The search number is specified by <x>. The search condition must be
set to ERROR.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:FLEXRAY:ERRTYPE
{CRCHeader|CRCTrailer|NUL LFRStatic|NULLFRDynamic|
SYNCFrame|STARTupnosync}
SEARCH:SEARCH<x>:TRIGger: A:BUS:FLEXRAY:ERRTYPE?
Arguments
Arguments are the available error types.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:FLEXRAY:ERRTYPE SYNCF RAME sets the
error type to SYNCFRAME.
2-668 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English