Commands listed in alphabetical order
SEARCH:SEARC
H<x>:TRIGger:A:LOGIc:USEClockedge
This command specifies whether or not Logic search uses a clock source. The
search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:LOGIc:USEClockedge {OFF |ON|0|1}
SEARCH:SEARCH<x>:TRIGger: A:LOGIc:USEClockedge?
Arguments
OFF specifies not to use the clock source.
ON specifies to use the clock source.
0 specifies not to use the clock source.
1 specifies to use the clock source.
Examples
SEARCH:SEARCH1:TRIGger:A: LOGIc:USEClockedge ONspecifies to use
the clock source.
SEARCH:SEARCH1:TRIGger:A: LOGIc:USEClockedge? might return
:SEARCH:SEARCH1:TRIGGER:A :LOGIC:USECLOCKEDGE 0 indicating not to
use the clock source.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:WHEn
This command sets or queries the condition for generating an A or B logic search
with respect to the defined input pattern.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:LOGIc:WHEn
{TRUe|FALSe|MOREThan|LESS Than|EQual|UNEQual}
SEARCH:SEARCH<x>:TRIGger: A:LOGIc:WHEn?
Arguments
TRUe searches on an input value that is true.
FALSe searc hes on an input value tha t is false.
MOREthan searches on an input value that is greater than a set value.
LESSthan searches on an input value that is less than a set value.
EQual searches on an input value that is equal to a set value.
2-722 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
