To Next Page

To Previous Page

Commands listed in alphabetical order

Group

Trigger

Syntax

TRIGger:{A|B}:BUS:B<x>:ETH ERnet:DATa:OFFSet <NR1>

TRIGger:{A|B}

:BUS:B<x>:ETHERnet:DATa:OFFS et?

Related Commands

TRIGger:{A|B}:BUS:B<x>:ETHERnet:CONDition

TRIGger:{A|B}:BUS:B<x>:ETHERnet:DATa:VALue

Arguments

<NR1> is an integer whose minimum and default values are -1 (don't care) and

maximum is 1,499.

Examples

TRIGger:A:BUS:B1:ETHERnet: DATa:OFFSet 36 sets the data offset to 36

bytes.

TRIGger:A:BUS:B1:ETHERnet: DATa:OFFSet? might return –1, indicating

that the data offset value is the default value, -1, meaning "don’t care".

TRIGger:{A|B}:BUS:B<x>:ETHERnet:DATa:QUALiﬁer

This command sets or queries the qualiﬁer to be used when triggering on an

Ethernet bus signal. The trigger condition must be set to DATa. The bus number

is speciﬁed by <x>.

Conditions

Requires the SR-ENET Triggering and Analysis application.

Group

Trigger

Syntax

TRIGger:{A|B}:BUS:B<x>:ETH ERnet:DATa:QUALifier {EQu al|

UNEQual|LESSthan|MOREthan| LESSEQual|MOREEQual|INrange|OUTrange}

TRIGger:{A|B}:BUS:B<x>:ETH ERnet:DATa:QUALifier?

Arguments

LESSthan sets the qualiﬁer to less than.

MOREthan sets the qualiﬁer to greater than.

EQual sets the qualiﬁer to equal.

UNEQual sets the qualiﬁer to not equal.

LESSEQual sets the qualiﬁer to less than or equal.

MOREEQual sets the qualiﬁer to greater than or equal.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-781

Tektronix MSO54 Programmer's Manual

Other manuals for Tektronix MSO54