Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Arguments
<QString> spec
ifies the header cycle count.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:FLEXRAY:HEADER:CYCLECount
"1010"
sets the header cycle count to XX1010.
SEARCH:SEARCH1:TRIGger:A: BUS:FLEXRAY:HEADER:CYCLECount? might
return
:SEARCH:SEARCH1:TRIGGER:A: BUS:FLEXRAY:HEADER:CYCLECOUNT
"XXXXXX"
indicating the cycle count has not been set.
SEARCH:SEARCH<x>:TRIGger:A:BUS:FLEXRAY:HEADER:FRAMEID
This command sets or queries the frame id portion of the binary header string
when searching on a FlexRay bus header. The search number is specified by <x>.
The search condition must be set to HEADer o r IDANDDATA.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:FLEXRAY:HEADER:FRAMEID
<QString>
SEARCH:SEARCH<x>:TRIGger: A:BUS:FLEXRAY:HEADER:FRAMEID?
Arguments
<QString> specifies the frame ID.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:FLEXRAY:HEADER:FRAMEID "1010"
sets the header frame ID to XXXXXXX1010.
SEARCH:SEARCH1:TRIGger:A: BUS:FLEXRAY:HEADER:FRAMEID? might
return
:SEARCH:SEARCH1:TRIGGER:A:BU S:FLEXRAY:HEADER:FRAMEID
"XXXXXXXXXXX"
, indicating the frame ID is a don’t care.
SEARCH:SEARCH<x>:TRIGger:A:BUS:FLEXRAY:HEADER:INDBits
This command sets or queries the Indicator bits portion of the binary header string
when searching on a FlexRay bus header . The search number is specified by <x>.
The search condition must be set to HEADer.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
2-672 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English