Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Arguments
<NR3> is the sou
rce threshold level for a pulse width trigger search.
Examples
SEARCH:SEARCH1:TRIGger:A: PULSEWidth:THReshold 1.0e -9 sets to
1.0 ns.
SEARCH:SEARCH1:TRIGger:A: PULSEWidth:THReshold? might return
:SEARCH:SEARCH1:TRIGGER:A :PULSEWIDTH:THRESHOLD 0.0 E+0
indicating the threshold is 0.0 s.
SEARCH:SEARCH<x>:TRIGger:A:PULSEWidth:WHEn
This command specifies to search for a pulse with a width
(duration) that is less than, greater than, equal to, or unequal to
a specified value (set using
SEARch:A:PULSEWidth:WIDth),
OR whose
SEARch:A:PULSEWidth:LOWLimit and
SEARch:A:PULSEWidth:HIGHL imit). The s earch number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:PULSEWidth:WHEn
{LESSthan|MOREthan| EQual|UNEQual|W IThin|OUTside}
SEARCH:SEARCH<x>:TRIGger: A:PULSEWidth:WHEn?
Arguments
LESSthan causes a search when a pulse is detected with a width less than the time
set by the SEARch:A:PULSEWidth:WIDth command.
MOREthan causes a search when a pulse is detected with a width greater than the
time set by the SEARch:A:PULSEWidth:WIDth command.
EQual causes a search when a pulse is detected with a width equal to the time
period specified in SEARch:A:PULSEWidth:WIDth within a ±5% tolerance.
UNEQual causes a search when a pulse is detected with a width greater than or less
than (but not equal) the time period specified in SEARch:A:PULSEWidth:WIDth
within a ±5% tolerance.
WIThin causes a search when a pulse is detected that is within a range set by
two values.
OUTside causes a search when a pulse is detected that is outside of a range set
by two values.
Examples
SEARCH:SEARCH1:TRIGger:A: PULSEWidth:WHEn Outside causes a search
when a pulse is detected that is outside the se t range.
2-726 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English