Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Syntax
MEASUrement:M
EAS<x>:REFLevels<x>:PERCent: FALLMid <NR3>
MEASUrement:MEAS<x>:REFLe vels<x>:PERCent:FALLMid?
Arguments
<NR3> is the percentage (where 50% is equal to MID) used to calculate the mid
reference level.
Examples
MEASUrement:MEAS1:REFLeve ls1:PERCent:FALLMid 50.0 sets the mid
reference level of the falling edge to 50%.
MEASUrement:MEAS1:REFLeve ls1:PERCent:FALLMid? might return
:MEASUREMENT:MEAS1:REFLEV ELS1:PERCENT:FALLMID 50.0 000
indicating the mid reference level of the falling edge is set to 50%.
MEASUrement:MEAS<x>:REFLevels<x>:PERCent:HYSTeresis
This command sets or queries the p ercentage (where 100% is equal to MAX and
0% is equal to MIN) used to calculate the hysteresis of the reference level when
the measurement's ref level method is set to percent. The measurement number
is specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:REFLe vels<x>:PERCent:HYSTeresis <NR3>
MEASUrement:MEAS<x>:REFLe vels<x>:PERCent:HYSTeresis?
Arguments
<NR3> is the hysteresis value used for the autoset.
Examples
MEASUrement:MEAS1:REFLeve ls1:PERCent:HYSTeresis 5. 0 sets the
hysteresis level to 5%.
MEASUrement:MEAS1:REFLeve ls1:PERCent:HYSTeresis? might return
:MEASUREMENT:MEAS1:REFLEV ELS1:PERCENT:HYSTERESIS 5 .0000
indicating the hysteresis is 5.0%.
MEASUrement:MEAS<x>:REFLevels<x>:PERCent:RISEHigh
This command sets or queries the percentage (where 100% is equal to TOP and
0% is equal to BASE) used to calculate the high reference level of the rising edge
when the measurement's re f level method is set to percent. The measurement
number is specified by x.
2-476 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English