Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Examples
SEARCH:SEARCH
1:TRIGger:A:BUS:FLEXRAY:DATa :OFFSet 2
sets the data
offset to 2 bytes.
SEARCH:SEARC
H1:TRIGger:A:BUS:FLEXRAY:D ATa:OFFSet?
might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:FLEXRAY:DATA:OFFSET -1, indicating
the data o ffset is don’t care.
SEARCH:SEA
RCH<x>:TRIGger:A:BUS:FLEXRAY:DATa:QUALifier
This command sets or queries the qualifier to be used when searching on a
FlexRay bus signal. The search number is specified by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Synta
x
SEARCH:SEARCH<x>:TRIGger: A:BUS:FLEXRAY:DATa:QUALifier
{EQUal|LESSEQual|MOREEQua l|UNEQual|LESSthan|MOREthan|
INrange|OUTrange}
SEARCH:SEARCH<x>:TRIGger: A:BUS:FLEXRAY:DATa:QUALifier?
Arguments
Argumentsaretheavailabledataqualifiers.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:FLEXRAY:DATa:QUALifier LESSTHAN
sets the data qualifier to less than.
SEARCH:SEARCH1:TRIGger:A: BUS:FLEXRAY:DATa:QUALifier? might
return
:SEARCH:SEARCH1:TRIGGER:A:BU S:FLEXRAY:DATA:QUALIFIER
EQUAL
, indicating the data qualifier is equal.
SEARCH:SEARCH<x>:TRIGger:A:BUS:FLEXRAY:DATa:SIZe
This command sets or q ueries the length of the dat
a string, in bytes, to be used
whensearchingonaFlexRaybusdatafield. The search number is specified by
<x>. The search condition must be set to IDANDDATA OR DATA.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
2-666 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English