Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Arguments
<NR1> is the dat
a offset value.
Examples
SEARCH:SEARCH1:TRIGger:A:B US:AUDio:DATa:OFFSet 2 sets the data
offset value to 2.
SEARCH:SEARCH1:TRIGger:A:B US:AUDio:DATa:OFFSet? might return
:SEARCH:SEARCH1:TRIGGER:A: BUS:AUDIO:DATA:OFFSET 1 indicating data
offset value is set to TDM channel 1.
SEARCH:SEARCH<x>:TRIGger:A:BUS:AUDio:DATa:QUALifier
This command sets or queries the qualifier to be used whe n searching
on an audio bus signal. The search condition must be set to DATa using
SEARCH:SEARCH<x>:TRIGger:A :BUS:AUDio:{NONTdm|TDM}:CONDition.
Thesearchnumberisspecified by <x>.
Conditions
Requires the SR-AUDIO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:
AUDio:DATa:QUALifier {EQual|UNEQual |
LESSthan|MOREthan|LESSEQua l|MOREEQual|INrange|OUTrange}
SEARCH:SEARCH<x>:TRIGger:A :BUS:AUDio:DATa:QUALifier?
Arguments
LESSthan sets the qualifier to less than.
MOREt
han
sets the qualifier to greater than.
EQua
l
sets the qualifier to equal.
UNEQual sets the qualifier to not equal.
LESSEQual sets the qualifier to less than or equal.
MOREEQual sets the qualifier to greater than or equal.
INrange sets the qualifier to in range.
OUTrange sets the qualifier to out of range.
Examples
SEARCH:SEARCH1:TRIGger:A:B US:AUDio:DATa:QUALifier L ESSthan
sets the qualifier to LES Sthan.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-639

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English