To Next Page

To Previous Page

Commands listed in alphabetical order

Examples

BUS:B1:I2C:DA

TA:SOURCE CH1_D5

sets the I2C SDA source to CH1_D5.

BUS:B1:I2C:DATA:SOURCE? might r eturn :BUS:B1:I2C:DATA:SO URCE

MATH1

,indica

ting that the I2C SDA source is set to MATH1.

BUS:B<x>:I2C:DATa:THReshold

This command sets or queries the I2C Data (SDA) source threshold for the

speciﬁed bus. The bus is speciﬁed by x.

Conditions

Requires option SR-EMBD.

Group

Bus

Syntax

BUS:B<x>:I2C:DATa:THResho ld <NR3>

BUS:B<x>:I2C:DATa:THResho ld?

Arguments

<NR3> is the I2C Data (SDA) source threshold for the speciﬁed bus.

Examples

BUS:B1:I2C:DATa:THReshold 50.0e-3 sets the threshold to 50 mV.

BUS:B1:I2C:DATa:THReshold ? might return

:BUS:B1:I2C:DATA:THRESHOL D 0.0E+0 indicating the threshold is set to 0 V.

BUS:B<x>:I2C:

RWINADDR

This command sets or queries the manner in which seven-bit I2C addresses are

represented in the busform display of the speciﬁed bus. The bus is speciﬁed by x.

Conditions

Requires option SR-EMBD.

Group

Bus

Syntax

BUS:B<x>:I2C:RWINADDR {0|1}

BUS:B<x>:I2C:RWINADDR?

Related Commands

BUS:B<x>:I2C:CLOCk:SOUrce, BUS:B<x>:I2C:DATa:SOUrce

2-146 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Programmer's Manual

Other manuals for Tektronix MSO54