Commands listed in alphabetical order
Syntax
MEASUrement:C
H<x>:REFLevels:ABSolute:RISE Low <NR3>
MEASUrement:CH<x>:REFLevel s:ABSolute:RISELow?
Arguments
<NR3> is the low reference level of the rising edge when the source ref level
method is set to absolute.
Examples
MEASUREMENT:CH2:REFLEVELS: ABSOLUTE:RISELOW 1.5 sets the low
reference level of the rising edge to 1.5 V.
MEASUREMENT:CH2:REFLEVELS: ABSOLUTE:RISELOW? might return
:MEASUREMENT:CH2:REFLEVELS :ABSOLUTE:RISELOW 1.0000 indicating
that the low reference le
vel of the rising edge is 1.0 V.
MEASUrement:CH<x>:REFLevels:ABSolute:RISEMid
This command sets or queries the value used as the mid reference level of the
rising edge when the source ref level method is set to absolute. T he channel
number is specified by x.
Group
Measurement
Syntax
MEASUrement:CH<x>:REFLevel s:ABSolute:RISEMid <NR3>
MEASUrement:CH<x>:REFLevel s:ABSolute:RISEMid?
Arguments
<NR3> is the mid reference level of the rising edge when the source ref level
method is set to absolute.
Examples
MEASUREMENT:CH2:REFLEVELS: ABSOLUTE:RISEMID 0 sets the mid reference
level of the rising edge to 0.0 V.
MEASUREMENT:CH2:REFLEVELS: ABSOLUTE:RISEMID? might return
:MEASUREMENT:CH2:REFLEVELS :ABSOLUTE:RISEMID 0.0E+0 indicating
that the mid reference level of the rising edge is 0 .0 V.
MEASUrement:CH<x>:REFLevels:ABSolute:TYPE
This command sets or queries the reference level type for the source. The channel
number is specified by x.
Group
Measurement
MSO54, MSO56, MSO58, MSO58LP Programmer 2-385
To Next Page
Loading...
Need help?
General
