Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Group
Power
Syntax
POWer:POWer<x>:HARMONICS:S TANDard {NONe | IEC | MIL | AM14}
POWer:POWer<x>:HARMONICS:S TANDard?
Arguments
NONe =Nostandard
IEC = IEC 61000-3-2 standard
MIL = MIL-STD-1399 standard
AM14 =AM14standard
Examples
POWer:POWer1:HARMONICS:STA NDard AM14 sets the test mode for harmonic s
measurement as AM14.
POWer:POWer<x>:HARMONICS:UNITs
This command sets or queries the harmonics results units in the specified power
measurement badge. The power m easurement badge is specified by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group
Power
Syntax
POWer:POWer<x>:HARMONICS:U NITs {LOG | LINear}
POWer:POWer<x>:HARMONICS:U NITs?
Examples
POWer:POWer1:HARMONICS:UNI Ts LOG sets the harmonics results units as
logarithmic.
POWer:POWer<x>:HARMONICS:VSOURce
This command sets or queries the voltage source for SOA measurement in the
specified power measurement badge. The power mea surement badge is specified
by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group
Power
MSO54, MSO56, MSO58, MSO58LP Programmer 2-543

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English